Nylon rod processing

Ordinary nylon has good mechanical properties and plasticity. It will be much better as long as you lightly hold it against the incoming car. However, it is impossible to ensure the straightness in the ideal state. It will definitely deform more or less, depending on how much you require!
If you want to ensure that you are in the best condition, I suggest using nylon 66+30GF, which has good rigidity and has a lot more strength than ordinary nylon; please refer to the following information for your reference in detail:
There are the following types of nylon 66:
1: Nylon 66 (cream color): Compared with nylon 6, its mechanical strength, stiffness, heat resistance and wear resistance, creep resistance are better, but the impact strength and mechanical shock absorption performance are reduced, which is very suitable for automatic lathes Machining.
2: Nylon 4.6 (red-brown): Compared with ordinary nylon, nylon 4.6 is characterized by strong rigidity preservation, good creep resistance, and more heat-resistant aging in a wider temperature range. Therefore, nylon 4.6 is used for Nylon 6, nylon 66, POM and PET cannot meet the requirements in terms of stiffness, creep resistance, heat aging, fatigue strength and wear resistance (80-150 ℃).
3: Nylon 66+GF30 (black): Compared with pure nylon 66, this nylon is reinforced with 30% glass fiber for its heat resistance, strength and rigidity. Creep resistance, dimensional stability, wear resistance and other properties have been improved, and its maximum allowable use temperature is higher.

4: Nylon 66+MOS2 (gray black): This nylon is filled with molybdenum disulfide. Compared with nylon 66, its rigidity, hardness and dimensional stability are improved, but the impact strength is reduced. The crystal grain formation effect of the crystalline structure improves the crystalline structure, and the material bearing and wear resistance properties are improved

Please send inquiry and drawing to sales@honyplastic.com