Ketron® CM CA30 - 30% Carbon Fiber-Filled PEEK

Ketron® CM CA30 PEEK is a compression molded, 30% carbon fiber-reinforced polyetherether ketone that exhibits outstanding impact, corrosion, chemical, and wear resistance. With a significantly reduced thermal expansion, optimum load carrying capabilities, and high thermal conductivity rates, Ketron® CM CA30 PEEK components are often favored for their ability to extend part life and rapidly dissipate heat in bearing applications. Ketron® CM CA30 PEEK shapes also excel in large parts applications, where high strength and stiffness are required.

Material Properties

30% carbon fiber reinforced

Outstanding resistance to impact, chemical corrosion and wear

Low thermal expansion

Optimum load carrying capabilities

High thermal conductivity rates

Rapid heat dissipation in bearing applications

Available Geometries

Ketron® CM CA30 PEEK stock shapes encompass a range of standard sizes in the following geometries: Tubular bar, Plate

Available Colors

Ketron® CM CA30 PEEK stock shapes come in the following colors: Black

Key Properties

Better Wear Properties Over Unfilled PEEK

Enhanced Dimensional Stability Over Unfilled PEEK

Higher Strength & Stiffness Over Unfilled PEEK

Higher Thermal Conductivity Over Unfilled PEEK

Compression Molded Grade Offers Larger Shapes & Thicker Cross Sections

Limitations

Poor Chemical Resistance to Halogens and Their Acids Including Bromine, Chlorine, Fluorine, HBr and HF

Applications

Back Up Rings

Bushings & Bearings

Heat Sink Components

Oil & Gas Components

Pump Case Wear Rings

Pump Throat Bushings

Rollers

Seals

Structural Components

Thrust Washers

Typical Properties of Ketron ® CM CA30 PEEK