POM plus 30% PTFE sheet rod

HONY®POM-30PTFE is made by blending POM and PTFE materials, which retains most of the strength of POM. After the addition of PTFE, the material properties change, softening, less rigidity, and smoother surface.Product features: low friction coefficient, wear resistance, basically no creeping phenomenon, good creep resistance; high impact strength even at low temperatures; very good dimensional stability; sliding performance is better than pure POM, excellent mechanical properties; Physiologically inert, suitable for contact with food.

Product shortcomings: not resistant to strong acids, especially mineral acids, not resistant to ultraviolet rays, and not fireproof

Extruded Acetal Pom Board is blended with other polymers with polyoxymethylene as the main body. The blended polymer made is called polyoxymethylene alloy. In recent years, with the continuous development of high-efficiency compatibilization technology, the production and application of POM alloys have developed rapidly. Advantages: Among all self-lubricating engineering plastics, polytetraethylene (PTFE) has the highest friction coefficient. Adding PTFE to POM to produce polyoxymethylene alloy can significantly reduce the friction factor of POM, improve the level of abrasion resistance and self-lubrication. Disadvantages: The mechanical strength and impact toughness have been reduced.

HONY®POM-30PTFE board application:

POM/PTFE alloy is suitable for manufacturing oil-free self-lubricating gears, precision gears, computer bearings, bearing rings, seals, cams, machinery industry, electronic communication equipment parts, etc. POM+PTFE is uniformly mixed with PTFE fiber in DELRIN polyacetal resin. It retains most of the inherent strength of DELRIN. Some properties are changed due to PTFE fiber. It is slightly softer, less rigid, and more slippery than pure polyacetal resin. It is suitable for making sliding parts, precision mechanical parts and water-resistant parts, such as bearings, gears, impellers, cams, and bushings. Materials for jigs, washers, guide rails, handles, handles, etc.

Application areas: bearings, gears, impellers, cams, bushes, washers, guide rails, handles, handles, etc., materials for fixtures.

Types: Rods, Sheets, Plates, Tubes, Profiles

Remark:

1."+" Tolerable ,   “-”Intolerable , "0"  Depends on the situation

2. The above data is obtained from raw material test data, which is not completely consistent with the performance of the finished product, and the uniqueness of the data is not guaranteed